Connect with H&H

DIY Carriage Lantern

DIY Carriage Lantern - House & Home

An old world look with a flameless candle.

Take inspiration from a foyer designed by Darryl Carter and create this sconce or lantern on the inside of a front door — it has an old world feel and cosies up an entry. 

Materials & Tools

  • Antique lantern
  • Finger-jointed pine trim
  • Saw
  • 1"-diam. dowel
  • Paint
  • Small and large round drawer pulls
  • Screws
  • Drill Small dish or votive holder
  • Wire or ribbon
  • Battery-powered candle

Step 1. Cut trim and level lantern

Measure the height of your lantern, and cut a length of finger-jointed pine trim to 1" longer. (Make sure the width of the trim is narrower than the centre panel of your door, too.) Next, you'll need to cut a length of dowel to ensure the lantern sits straight against the door, instead of tilting forward at an angle. Set the lantern on the wood, and lift the base until it's parallel to the trim. Measure the distance between the wood and the lantern base, then cut the dowel to that length. (We cut the dowel to 1 1⁄2".) Paint the pine trim and the dowel the same colour as the door so they blend into the background.

Step 2: Create lantern holder

Pick out two round drawer pulls in similar styles but different sizes. The smaller pull simply screws into the pine trim using the included hardware. The larger pull, however, will need to be attached through the dowel, so buy a longer screw if needed. For example, if dowel was 1 1⁄2" long, so you will need needed a 2" screw. Attach the smaller pull 1⁄2" from one end of the trim, and the larger pull 1⁄2" from the other end.

Step 3: Attach trim to door

Measure 2 1⁄2" in from each end of the trim, and make two marks. These are the points where you'll screw the trim to the door. Measure the distance between the marks, and drill two corresponding holes in the interior side of the door. Screw the trim to the door, with the larger drawer pull at the bottom, and cover all screw heads with paint.

Step 4: Assemble lantern and set in holder

If your lantern has an oil canister inside, remove and replace with a brass dish or glass votive holder. Set the lantern in the larger drawer pull, and tie the top of the lantern to the smaller drawer pull with wire or ribbon to hold it in place. Switch on the candle, place in the dish or votive holder and enjoy.

Battery-operated candle, Bed Bath & Beyond; trim, dowel, screws, The Home Depot; drawer pulls, Lee Valley.

Get more DIY & Home Improvement ideas in our guide.

Author: 

Meg Crossley

Photographer: 

Valerie Wilcox

Comment Guidelines

We welcome your feedback on Houseandhome.com. H&H reserves the right to remove any unsuitable personal remarks made about the bloggers, hosts, homeowners and/or guests we feature. Please keep your comments focused on decorating, design, cooking and other lifestyle topics. Adopt a tone you would be willing to use in person and do not make slanderous remarks or use denigrating language. If you see a comment that you believe violates any of the guidelines outlined above, please click “Alert a Moderator.” Thank you.

OK