Is it possible to sand just a couple of pieces of wood and revarnish ??
In my kitchen the wood floor is almost perfect except a small aera where the finish is gone. I am wondering if it would be possible to just tape an sand 3 or 4 boards. I am feeling funny to ask this kind of silly question :rolleyes:
It is a very small section between ceramic tiles and kitchen island, it is the place where the dog of the house walk with wet feets :)
Comment Guidelines
We welcome your feedback on Houseandhome.com. H&H reserves the right to remove any unsuitable personal remarks made about the bloggers, hosts, homeowners and/or guests we feature. Please keep your comments focused on decorating, design, cooking and other lifestyle topics. Adopt a tone you would be willing to use in person and do not make slanderous remarks or use denigrating language. If you see a comment that you believe violates any of the guidelines outlined above, please click “Alert a Moderator.” Thank you.
Sure you can. It would be like refinishing any wood with the same problem. Although it's nice when you do the whole surface, if you can match the finish and sand a bit you should be able to repair the part you want without it being too noticeable.
You might check some stores to see what products are out there because some will probably level better to the original.
I had a wood floor that had been attacked by nail polish remover. So I did try to fix it up. Although it wasn't perfect, it did the job nicely until we were ready to refinish the floors.